When a coin's funding rate on Hyperliquid runs high, the shorts collect what the longs pay every hour. A funding rate arbitrage tries to collect that payment without betting on the price: you hold the coin and short the same amount on the perp, so the two price moves cancel out. On paper the rate looks like a yield. In practice fees, the spread and the rate itself moving take a large share of it. Below is how the trade works, with one week of it worked out in numbers. It is not advice to place it.
How Hyperliquid funding works
Hyperliquid charges funding every hour. The rate is a fixed interest part of 0.00125% an hour plus a premium part that measures how far the perp trades from its oracle price, and each payment is your position size times the oracle price times the rate. When the rate is positive, longs pay shorts. When it is negative, shorts pay longs. The Hyperliquid funding rate post explains the formula in full and how to compare an hourly rate with exchanges that settle every 8 hours.
How a delta-neutral funding trade works
Delta-neutral means the position as a whole barely moves with the price. There are two common ways to set one up.
Long spot, short perp. Buy the coin on spot and short the same amount on the Hyperliquid perp. If the price rises, the spot leg gains what the short loses, and the other way round. While the rate stays positive, the short collects funding every hour.
Across two exchanges. Short the perp where the rate is high and go long the same perp on an exchange where it is lower. You collect on one side and pay on the other, and you keep the gap. Most other exchanges settle funding every 8 hours and charge only the positions open at the settlement time, while Hyperliquid counts every hour, so the two legs are not paid on the same clock.
Either way you close both legs when the rate falls back, and the trade only made money if the funding you collected covered everything it cost.
What eats the yield
Fees on four fills. Two to open and two to close, one on each leg. Taker fills cost more than maker fills, and spot fees are often higher than perp fees.
The spread between the legs. You rarely buy spot and short the perp at exactly the same price. When the spot fill is a few dollars above the perp fill and both close at the same price later, that gap is a cost.
The rate moving. A high rate means many traders are long on the perp, and that can change fast. The rate can drop back to the baseline within hours, and it can go negative, and then your short pays every hour you hold.
Liquidation risk on the perp leg. The short is still a leveraged position. A sharp rise can liquidate it if it has too little margin, even though the spot leg gained the same amount. If the two legs sit in different accounts or on different exchanges, the spot gain does nothing for the short's margin.
Capital tied up. You pay for the whole spot leg and put up margin for the short. The yield has to be measured against all of that money, not against the perp's value alone.
A worked example on Hyperliquid
These are example numbers. The perp fee is Hyperliquid's base taker rate of 0.045%. The spot fee of 0.07% is an example; check your own fee tier for both.
You buy 2.5 ETH on spot at $4,004, which is $10,010, and short 2.5 ETH on the perp at $4,000, which is $10,000, with $2,000 of margin. Funding averages 0.0025% an hour, twice the baseline, for the 168 hours of one week. You close both legs with ETH at $4,200.
| Line | How it is worked out | Amount |
|---|---|---|
| Spot leg | 2.5 × ($4,200 − $4,004) | $490.00 |
| Perp leg | 2.5 × ($4,000 − $4,200) | −$500.00 |
| Spot fees | ($10,010 + $10,500) × 0.07% | −$14.36 |
| Perp fees | ($10,000 + $10,500) × 0.045% | −$9.23 |
| Funding received | 168 hours × ($10,000 × 0.0025%), so 168 × $0.25 | +$42.00 |
| Net PnL | $8.41 |
The two price legs cancel apart from the $10 spread you paid on entry. The funding of $42 is real, but fees and the spread take $33.59 of it.
Against the money tied up, $10,010 of spot plus $2,000 of margin, $8.41 is about 0.07% for the week. The rate of 0.0025% an hour sounds like 21.9% a year on the perp's value. Net of costs and measured on all the capital, this week ran at less than 4% a year.
If the rate had fallen back to the 0.00125% baseline for the week, funding would have been $21.00 and the trade would have lost $12.59. In this example the rate has to average about 0.002% an hour just to cover its costs. To keep the arithmetic simple, funding here uses the $10,000 entry value; in reality each hour uses the oracle price at that hour, so it grew a little as ETH rose.
You can run your own position size, rate and hours in the free funding fee calculator, with 1 hour as the funding interval for Hyperliquid.
The honest limits
The numbers above are one week at one average rate. Real rates change every hour, so you only know what a funding trade earned after you close it. Fees, the spread and the time the rate stays high decide the result far more than the headline rate does. A trade that looks neutral can still lose money, through a liquidated short, a negative rate or a wide exit. None of this makes a funding trade free money or free of risk.
If the rate is high because you are on the paying side, the Hyperliquid funding too high post goes through your options, from holding for fewer hours to hedging with spot.
If you trade on Hyperliquid, connect your wallet address to a free Viktury journal and see what each trade really collected or paid in funding.
Tracking a funding trade in Viktury
In Viktury's Hyperliquid trading journal, you add an account with your wallet address and no key. Spot trades and perp trades both come in through the wallet sync, so a long spot, short perp trade shows up as its two legs. Each hourly funding payment is attached to the perp trade that was open when it was charged, and that trade's net PnL includes it. Fees come in as each fill actually paid them, and a maker rebate shows as a negative fee. Add the two legs together and you have the same table as above, from your own fills.
Open a free Viktury account and paste your Hyperliquid wallet address.